Teesa TSA2011, Инструкция по эксплуатации

Страница: 21 / 72

Owner’s manual 21
EN
17. Appliance for indoor and household use only. Not for commercial use.
18. Never place the device on hot surfaces (e.g. hot plates) or near heat sources or open fire.
19. WARNING: During operation, according to selected settings, steam will be ejected - RISK
OF SCALDING!
20. DO NOT TOUCH THE SOLEPLATE DURING OPERATION, NOR UNTIL IT HAS COMPLETELY
COOLED DOWN!
21. DO NOT leave the hot iron touching fabrics or very inflammable surfaces.
22. The iron should always be turned to “min”, and the steam function turned to “0” before
plugging or unplugging from outlet.
23. Do not allow cord to touch hot surfaces. Let iron cool completely before putting away.
24. Loop cord loosely around iron when storing.
25. Burns can occur from touching hot metal parts, hot water, or steam. Use caution when
you turn a steam iron upside down – there may be hot water in the reservoir.
26. Always disconnect iron from electrical outlet when filling with water or emptying, and
when not in use.
27. In case of any abnormality, when the iron is not operating normally, disconnect it from
the power supply and have the device serviced by qualified service personnel.
28. The iron must be used and rested on a stable surface.
29. Do not use chemical additive, scented substances or decalcifiers. Failure to comply with
the above-mentioned regulations leads to the loss of guarantee and may damage the
device.
30. DO NOT use this device if the power cord, the plug or the device itself shows visible
damage, or if the appliance has been dropped, is damaged or leaks.
31. Do not attempt to repair/disassemble this device yourself. In case of damage, contact
with an authorized service point for check-up/repair.
32. IMPORTANT: In order to ensure children‘s safety, please keep all packaging (plastic bags,
boxes, etc.) out of their reach. Caution! Do not allow small children to play with the foil
as there is a danger of suffocation!
BEFORE FIRST USE
1. Remove any sticker, protective foil or storage cover from the soleplate if present and
clean the base with a soft cloth.
2. Connect to power supply and heat up the iron to maximum temperature and iron over
a piece of damp cloth for several minutes for the purpose of removing any residue on
the soleplate (some particles may come out of the soleplate when you use the iron for
the first time. This is normal; the particles are harmless and stop coming out of the iron
after a short while).
3. When using the iron for the first time, you may notice a slight emission of smoke, peculiar
odor and hear some sounds made by the expanding plastics. This is quite normal and it
stops after a short time (certain parts of the iron have been lightly greased; therefore the
iron could give off a little smoke when plugged in for the first time. This will cease after
a short while).