TED Pro Commercial, Руководство по установке

Страница: 6 / 24

Page 6
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
PA R T I I – S A F E T Y
THE MTU AND CT
s
OF THE TED PRO COMMERCIAL sYsTEM MUsT BE
INsTALLED BY A LICENsED ELECTRICIAN
This manual provides the steps necessary to safely install the MTU and Current Transformers (CTs).
For detailed installation and operation of other components and software, please find it on the TED
website:
www.theenergydetective.com
Every effort has been made in providing for the safe, secure installation of TED. The installation of
TED requires the cover of the main electrical circuit breaker panel to be removed. After the circuit
breaker panel cover has been removed, the potential hazard of shock, burn, or even electrocution
now exists. Do not attempt to complete this installation unless you are a licensed electrician familiar
with the electrical components and operation of the circuit breaker panel. Even when the main circuit
breaker has been turned to the “OFF” position, certain areas within the circuit breaker panel may still
be electrified. Do not attempt installation unless you know where these electrified areas are.
This symbol will be found throughout
the instructions where there is a po-
tential for electric shock, burn, or even
electrocution. Do not attempt to com-
plete the noted section if you are not
an electrician, or qualified installer
.
WARNING - These servicing instructions are for use by qualified personnel only. To reduce the risk of
electric shock, DO NOT perform any servicing other than that contained in these operational instruc-
tions unless you are qualified to do so.
WARNING - The MTU must be connected to a switch or circuit breaker in close proximity to the equip-
ment and within easy reach of the operator. It must be marked as the disconnecting device for the MTU.
WARNING - If the equipment is used in a manner not specified in these instructions, the protection
provided by the equipment may be impaired.
TESTED TO COMPLY WITH
FCC STANDARDS
FOR HOME AND OFFICE USE
E
nErgy
, I
nc
. M
odEl
TEd3000 / TEd P
ro
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) This device must accept any interference received,
including interference that may cause undesired operations.
FCC Part 15 SubPart B
EU/EN 61326-1
netzerotools.com
netzerotools.com