P. 4
English Version
| Tecshow HALO 715 XL
Overhead mounting requires extensive experience,
including among others calculating working load
limits, a fine knowledge of the installation material
being used ,and periodic safety inspection of all
installation material and the fixture. If you lack these
qualifications.
The LED moving head provides a unique mounting
bracket assembly that integrates the bottom of the
base, the included ‘omega bracket’ and the safety
cable rigging point in one unit (see the illustration
below). When mounting this fixture to truss be sure
to sere to secure an appropritely rated clamp to the
included omega bracket using a M10 screw fitted
through the center hole of the ‘omega bracket’.
As an added safetymeasure be sure to attached at
least one properly rated safety cable to the fixture
using on of the safety cable rigging point integrated in
the base assembly.
Connect the provided XLR cable to the female 3-pin
XLR output of your controller and the other side to the
male 3-pin XLR input of the moving head.
You can chain multiple Moving head together through
serial linking. The cable needed should be two core,
screened cable with XLR input and output connectors.
Please refer to the diagram below.
3. MOUNTING POINTS
4. CLAMP MOUNTING
5. DMX-512 CONTROL CONNECTION
Do not attempt the installation yourself ,improper
installation can result in bodily injury.
Be sure to complete all rigging and installation
procedures before connecting the main power cord to
the appropriate wall outlet.
