TECOM TS1066, Руководство по программированию

Страница: 92 / 110

Management via CTPlus
Note: Typically, management of a NAC will be done using TecomC4. The
following information is for using CTPlus to manage a NAC if required.
CTPlus can be used to manage the Network Access Controller:

The status of the NAC can be viewed in the device tree in the Status and
control window. See the “Status and control” section below.

Devices can be controlled from the device tree by sending commands in
the Status and control window. See the “Status and control” section below.

Up to 100 door schedules can be configured via the Door schedule form,
as described in the “Configuring door schedules” section on page 93. For
more information on door schedules, see the “Overriding door state”
section on page 24.

A door override can be configured for each door via the Door override
form, as described in the
“Configuring door overrides” section on page 95.
For more information on door overrides, see the “Overriding door state”
section on page 24.
Status and control
The Network Access Controller can be monitored for its status (including the
status of polled devices on its buses) and controlled via CTPlus
’s
Status and
Control window.
To open the Status and Control window, click the Status and Control button
on the Operation ribbon tab.
The NAC devices that appear in the device tree of the Status and control window
depend on the operating mode of the NAC.