Tecom Smart Portable Vibration Diagnosis Instrument operation manual
Page 19
14-2 Horizontal
When the vibration gauge is installed in the horizontal direction, it should be
placed on the level of the rotation axis, does not put too high, so as not to
increase the vibration value. Put the higher position, the greater the value of the
horizontal vibration. At this time, the Z axis of the vibration gauge is the
horizontal direction. If you measure only one point, it is recommended to use this
point. Vibration measurement of the vertical direction, to be placed on top of the
rotating shaft, then the vibration of the Z-axis is the vertical direction, please note
that the two legs of the magnet parallel to the axis of rotation, it can be fixed in
the motor arc on.
Z
X
Z
X
Y
X
Y
X
X
Z
X
X
Z
X
When using a horizontal mounting
position, the figure represents the
correct measured axial direction of
vibration.
