TECO MOTOVARIO PBH Series, Инструкция по установке, использованию и техническому обслуживанию

Страница: 29 / 56

Pressure switch:
It signals, through an alarm, when the pressure drops under the minimum permissible value (0.5 bar). All connections must
be implemented by the customer.
For any technical information, please contact MOTOVARIO TECHNICAL SERVICE.
In any case, refer to the installation manual of the part to be assembled.
Never change the pressure switch triggering value!
Periodically check the correct operation.
Oil level probe with float (PBH only):
It is used for the remote reading of oil level. It is supplied already calibrated and triggers as soon as the level is below the
set threshold.
For any technical information, please contact MOTOVARIO TECHNICAL SERVICE.
In any case, refer to the installation manual of the part to be assembled.
Before filling up, check probe correct operation.
Periodically check the correct operation.
Oil temperature probe PT100:
It is used for the remote reading of oil temperature. It is fitted instead of the draining cap or the pre-drilled hole. All
connections must be implemented by the customer.
For any technical information, please contact MOTOVARIO TECHNICAL SERVICE.
In any case, refer to the installation manual of the part to be assembled.
Periodically check the correct operation.
​
Bearing oil temperature probe PT100:
It is used for the remote reading of bearing temperature. It is assembled inside the special hole present on the bearing to
be monitored. Make sure that probe tip is in contact with the outer surface of the bearing. All connections have to be
made by the customer.
For any technical information, please contact MOTOVARIO TECHNICAL SERVICE.
In any case, refer to the installation manual of the part to be assembled.
Periodically check the correct operation.
Bimetal thermal fuses (PBH only):
Thermal fuses are calibrated for a fixed triggering temperature, based on the accessory (or device) and on their function.
They can be assembled on the gear reducer or supplied as an outfit (in this case, replace the closing caps, marked and
used for transport, with thermostats). All connections must be implemented by the customer.
For any technical information, please contact MOTOVARIO TECHNICAL SERVICE.
In any case, refer to the installation manual of the part to be assembled.
Periodically check the correct operation.
MHD reducers
QL0336
∕
REV.2
Instructions for installation, use and maintenance
27