TECO MOTOVARIO PBH Series, Инструкция по установке, использованию и техническому обслуживанию, Страница: 14 / 56

6.3 STORAGE
The units must be stored according to the following requirements:
Be placed as per specified mounting position of the label;
Be free from vibration and protected from accidental impacts;
Be kept at relative humidity <50%, with no intense temperature change, no ultraviolet light and no direct sunlight;
In case of low temperatures (Tamb < -5°C) take special care to avoid shocks and vibration that could damage the
structure.
In the event of storage for 6 months or more, or in environmental conditions other than those specified:
Fill up the gear reducer with oil. Restore the suitable level when commissioning the transmission;
Every six months, rotate the shafts by a few turns to avoid damage to the bearings and prevent the sealing rings from
being glued.
Apply plenty of grease or suitable protective and water-repellent products on the shafts and surfaces processed in
order to prevent metal oxidation or deterioration of rubber parts;
Caution! The formation of oxide on metal surfaces considerably reduces the energy required for the spark in the event of
a collision, thereby increasing the chances of ignition. Always make sure processed surfaces are free from oxide and
protected.
In case of units featuring a drywell or for other types of storage, contact MOTOVARIO TECHNICAL SERVICE.
MHD reducers
QL0336
∕
REV.2
Instructions for installation, use and maintenance
12