B10
Via Bonazzi, 4 - 40013 Castel Maggiore (BO)
Tel. +39 051 700096 (10 linee) - Fax +39 051 700175
[email protected] - www.tecnotelai.it
!
/
!
2 3
Attach the angle bar supporting the top in the upper holes of the outer side of the drawers unit with 2 flanged
screws TE 8x16 near the welded nuts inside.
FITTING THE TROLLEY HANDLE
Within the 1st or 2nd drawer, the handle to be fixed is inserted with 2 oval
head screws 6x12.
1
6
MOUNTING THE TOOL BENCH
wooden top
"U" profile
undermount
side panel
angle bar
supporting
the top
Pull out the drawers near the lower holes of the drawers unit.
2
Insert the "U" profile inside the drawers unit, and with 2 flanged screws TE 8x16, attach it to the drawers unit
and undermount, then lock by means of the washer and of 2 nuts of 8; finish the installation of the undermount
by securing the side panel using 2 flanged TE screws 8x16 and 2 tab nuts.
3
Place the work top on the structures and insert the countersunk head screws 8x55 in correspondence with the
holes on the side and/or the support angle bar of the top; screw with washers and nuts supplied.
4
Once the assembly is completed, check and tighten all screws.
5
