16 of 20
II_PulsePro_05_eng
Installation instructions
Pulse PRO
Functional tests
To be carried out with the door open.
MEMBRANE TEST:
Press and hold button 5 until the double beep (the LED will remain on).
Slowly enter all the buttons according to the sequence below:
[1]-[2]-[3]-[4]-[5]-[6]-[7]-[8]-[9]-[0]-[P]-[OK]
A double beep after pressing each single button indicates that the keypad correctly communicates
with the lock.
A long beep indicates an electronic problem (in this case please contact the technical assistance).
ELECTRONIC / MECHANICAL TEST:
OPENING:
Enter the opening code (standard manager code 60-123456 or simply 1 if the lock is in pre-setup
mode). The lock emits a double beep. You will hear a long beep in case of incorrect code.
With SwingBolt, MotorLock and Motor LatchBolt locks, turn the safe door handle to the open
position.
With DeadBolt and LatchBolt locks, rotate the knob or keypad according to the type of installation
and move the lock bolt to the open position.
For all types of locks the bolt must be able to move freely.
LOCKING:
With SwingBolt and MotorLock locks, turn the safe door handle to the locked position. Lock bolt
must fully extend and ensure locking.
With MotorLock and Motor LatchBolt locks with manual reclosure, turn the door handle towards
the locked position and press the button
P
.
With DeadBolt locks, turn the knob or keypad to the locked position.
With LatchBolt and Motor LatchBolt locks, push the door to close.
For all types of locks, at the end of the operation the bolt must fully extend and ensure locking.
Repeat the functional test several times before locking the safe door.
Failure to follow these installation instructions or opening the lock by personnel not
authorized by Tecnosicurezza will void the warranty.