II_Pulse_12_eng
9 of 20
Installation instructions
Pulse
Keypad rotating kit installation instructions (accessory, p.n. T3300)
The rotation kit consists of 2 bushings, 2 M4 countersunk screws, 1 plastic pin, 1 spring and 1
rotating backplate.
(Imperial screws 8-32 UNC are available on request.)
Cut the grooved shaft to the appropriate length: measure door thickness (from mounting
surface of the entry unit to the mounting surface of the lock) and add 26 mm (1”). Prepare the
mounting and cable holes.
Fix the screws (M4) and the rotating backplate, positioning the latter on the side marked "UP".
Fix the bushings to the keypad housing using the supplied screws.
Insert the pin completely in the spring and then place it into the specific hole in the case.
Insert the grooved shaft, with the cutting edge first, all the way into the keypad housing.
Place the connection cable inside the groove in the spindle.
Insert the cable and the spindle inside the spindle hole made in the door, keeping the keypad in
angled position (10:00 o’ clock) hook the keypad to the rotating backplate.
Then turn unit clockwise into position at 12:00 o’ clock until you hear a click, reaching the final
position.
