16 of 20
II_Pulse_12_eng
Installation instructions
Pulse
Functional test
To be carried out with the door open.
MEMBRANE TEST:
Press and hold button 5 until the double beep (the LED will remain on).
Slowly enter all the buttons according to the sequence below:
[1]-[2]-[3]-[4]-[5]-[6]-[7]-[8]-[9]-[0]
A double beep after pressing each single button indicates that the keypad correctly communicates
with the lock.
A long beep indicates an electronic problem (in this case please contact the technical assistance).
OPENING
:
Enter the opening code (standard code 123456 or simply 1 if the lock is in pre-setup mode).
The lock emits a double beep. You will hear a long beep in case of incorrect code.
With SwingBolt and MotorLock locks, turn the safe door handle to the open position.
With DeadBolt and LatchBolt locks, rotate the knob or the keypad according to the type of
installation and move the lock bolt to the open position.
For all types of locks the bolt must be able to move freely.
LOCKING
:
With SwingBolt and MotorLock locks, turn the safe door handle to the locked position. Lock bolt
must fully extend and ensure locking.
With MotorLock locks with manual reclosure, turn the door handle towards the locked position
and press any button.
With DeadBolt locks, turn the knob/keypad to the locked position.
With LatchBolt locks, push the door to close.
For all types of locks, at the end of the operation the bolt must fully extend and ensure locking.
Repeat the functional test several times before locking the safe door.
Failure to follow these installation instructions or opening the lock by personnel not
authorized by Tecnosicurezza will void the warranty.
