Tecnomac ChillRapid T20, Инструкция по эксплуатации

Страница: 15 / 34

GB
44
• If at the end of the maximum blast chilling interval the core probe continues to display a tem-
perature higher than the value for the end of blast chilling, the displays will indicate an alarm
for excessively long chilling (ALL 14) alternating with the temperature and time; at the same
time, the alarm beep will be activated.
The blast chilling cycle continues until the end chilling temperature has been reached; dis-
play 15 counts back the minutes remaining until the end of the cycle.
NB: Press push-button
8
to mute the alarm; press push-button again to clear the
alarm display
• At the end of the chilling cycle, the appliance automatically switches to the set storage tem-
perature for an indefinite interval (like a standard storage appliance).
NB: LEDs 13 switch off while LEDs 14 light up.
• The cell temperature is constantly shown on display 16 ; during this cycle, defrost
cycles are performed at regular intervals with duration set as required (parameter pro-
gramming reserved for installation technician). The factory setting for positive storage tem-
perature is +2°C.
• Press push-button 6 to set the appliance to STOP status (relative LED switches off),
ready for a new cycle.
To modify the final blast chilling temperature, consult the user programming instructions.
5.3 SOFT TIMED BLAST CHILLING
• Press push-button 2 (relative LED lights up), then press push-button 5 to select
the timer mode (LED 5B on). Display 15 shows the maximum chilling time (set by
default to 90 minutes).
To modify this time, press push-buttons 7 and 8 (time in minutes).
• Press push-button 6 to start the appliance. LED 5B and push-button LEDs remain
on and LEDs 13 flash throughout the cycle.
• Internal cell temperature is shown on display 16 .
• When the maximum chilling time has counted back to 0, the chilling cycle is completed and
the appliance automatically switches to the set positive storage temperature for an indefi-
nite interval.
• LEDs illuminate and the beep is activated when the cycle is finished (as in the chilling cycle
by temperature). The same applies for the positive storage function.
Press push-button 6 to set the appliance to STOP status (relative LED switches off),
ready for a new cycle.