Tecnoinox GRE, Инструкция по установке и использованию

Страница: 7 / 22

03/2003
GB / IE - 1
5410.254.00
Part 1 Installation
ELECTRIC GRILL
General Instructions
The appliance referred to in this manual has been
manufactured in conformity to the following Directives:
73/23/EEC, 93/68/EEC “Low Voltage”; 89/336/EEC,
92/31/EEC, 93/68/EEC and EN55014 “Electromagnetic
Compatibility.
The technical specifications of the appliance can be
found on the data plate located inside the control panel,
which can be removed by loosening the two screws
under the panel.
The appliance must be installed by a qualified technician
according to the regulations and directives in force in the
country where it is installed, as well as the instructions in this
manual. The appliance must only be used by trained
personnel and only for the purpose for which it has been
designed. The appliance should be checked once a year by a
qualified technician.
Remove the packaging from the appliance as well as the
protective plastic sheet, and, if necessary, remove traces of
glue with a suitable solvent. To dispose of the packaging,
follow local directives.
When installing the appliance, the following regulations must
be observed:
ƒ
Applicable national laws in force;
ƒ Regional and/or local regulations, such as building
codes;
ƒ
Directives and regulations of the local electricity board;
ƒ
Accident prevention regulations in force;
ƒ Fire prevention regulations;
ƒ Applicable I.E.C. regulations.
The appliance should be installed under an extractor fan for
removing cooking fumes.
The appliance can be installed alone or in line.
Respect a minimum distance of 80mm between the
appliance and any walls made of flammable material,
partitions, kitchen furniture or nearby equipment. The
surfaces in contact with the appliance must be covered with
non-combustible heat insulating material. The appliance, and
especially the power lead, must not be installed anywhere
near heat sources and the temperature of the place in which
the appliance is installed must not rise above 50°C.
Connection to the distribution network
Before connecting the appliance note the specifications:
voltage, frequency, number of phases and power on the data
plate, relevant to the power input of the same.
The installer must make the connection after having
installed a main switch, which should disconnect every pole
supplying electrical power to the appliance. The switch
supplying electrical energy to the appliance must have a
minimum distance of at least 3 mm between the poles when
the contacts are open. The switch must be easy to reach.
The power lead must not be installed anywhere near heat
sources and the temperature of the place in which the cable
is installed must not rise above 50°C. The cable must be
protected by a rigid metal or plastic tube. The appliance is
supplied without a power cable. The electric cable used to
supply power to the appliance must at least meet H07 RN-F
standards. It must have the minimum section indicated in the
table (fig.1).
To reach terminal board “ M ” (fig.2), remove the control
panel by loosening the screws on the lower part of the panel.
Following the indications in the wiring diagram, connect
the wires of the power cable to the terminal board.
The appliance must be connected to a good earth. There is a
screw marked with the symbol
: near the terminal board
where the earth conductor should be connected.
Make sure you slide the cable through the relevant hole " P "
(fig.2) near the terminal board, hold the cable in place until
you can block it with cable clamp “ AL ” (fig.1).
The appliance must be connected to a good earth.
The appliance must also be connected to an
equipotential earth. Connect the earth with the screw marked
9 on the rear panel of the appliance.
The equipotential wire must have a section of 10 mm
2
.
The Manufacturer declines any responsibility for damage caused by improper or incorrect installation or maintenance of
the appliance, or failure to observe safety regulations!