GB / IE - 1
5410.310.00
Part 1
Installation
ELECTRIC COOKERS WITH ELECTRIC OVEN
General Instructions
The appliance referred to in this manual has been manufactured in
conformity to the following Directives: “Low Voltage” &
“Electromagnetic Compatibility.
The appliance must be installed by a qualified technician according to
the regulations and directives in force in the country where it is
installed, as well as the instructions in this manual.
This appliance has been designed exclusively for cooking food.
Remove the packaging from the appliance as well as the protective
plastic sheet, and, if necessary, remove traces of glue with a suitable
solvent. To dispose of the packaging, follow local directives.
When installing the appliance, the following regulations must be
observed:
Applicable national laws in force;
Regional and/or local regulations, such as building codes;
Directives and regulations of the local electricity board;
Accident prevention regulations in force;
Fire prevention regulations;
To use the appliance correctly follow the warnings below:
The appliance must never be left unattended when it is being used!
The appliance is designed for professional use and therefore
should only be used by qualified personnel.
Care must be taken when using the appliance because the
cooking surfaces are very hot.
The appliance should be installed under an extractor hood for
evacuating the cooking fumes.
If the appliance is installed in line:
Respect a minimum distance of 80mm between the appliance and
any walls made of flammable material, partitions, kitchen furniture
or nearby equipment.
The surfaces in contact with the appliance must be covered with
non-combustible heat insulating material.
The appliance, and especially the cable, must not be installed near
heat sources.
The temperature of the environment in which the appliance is
installed must not exceed 50°C.
Switch the appliance off in the case of failure or malfunction.
Connection to the mains
Before connecting the appliance note the specifications necessary for
the installation: voltage, frequency, number of phases and power on
the data plate of the appliance.
The self adhesive polyester data plate is behind the
panel “T” pic.1.
The installer must make the connection after having installed a main
switch, which is easy to reach and disconnects every pole supplying
electrical power to the appliance.
The switch supplying electrical energy to the appliance must have a
minimum distance of at least 3mm between the poles when the
contacts are open.
THE CABLE:
Must not be installed near heat sources, the temperature
surrounding the appliance must not exceed 50°C.
Must be protected by a metal or a plastic tube
Must at least meet H07 RN-F standards.
Must have the minimum section indicated in the table (page III).
To reach terminal board “M” pic .2, remove the rear panel. Following
the indications in the wiring diagram, connect the wires of the power
cable to the terminal board.
The appliance must be connected to a good earth. There is a screw
marked with the symbol near the terminal board where the earth
conductor should be connected.
Hold the power cable in place on the bottom, blocking it in place with
the relevant cable clamp “AL” pic.1.
The appliance must also be connected to an equipotential earth. Such
connection takes place by a screw marked as placed on the back
of the appliance.
The equipotential wire must have a section of 10mm
2
.
