Electric Oven rev.0
________________________________________________________
EKF 2011 UD – EKF 1664 UD
_________________________________________________________________________________________ pag 19
9.5 Cleaning the door
The glass on the door inside the cooking chamber can be cleaned with the same degreaser as
used for cleaning the chamber or a normal glass cleaning product can be used (non toxic).
Normal glass cleaning products can also be used to clean the glass on the outside of the door,
or simply warm soapy water, rinse and then dry the glass well with a soft cloth.
If dull marks form between the two door glasses, these can be removed by dismantling the
external glass.
To do this act on the appropriate hooks for closure of the glass.
After cleaning the glass close the external glass acting on reverse.
9.6 Cleaning the external casing
The external steel surfaces should be cleaned with a cloth soaked in warm soapy water or with
a drop of vinegar added, they should be rinsed well and dried with a soft cloth. If you use
specific cleaning products, they must correspond to the requirements for cleaning given in the
paragraph “General information”. You should also remember that the table the appliance
stands on or the surrounding floor should not be cleaned using corrosive acid products (for
example muriatic acid), as the fumes that are given off could attack and damage the external
steel casing.
9.7 Periods without use
If the appliance is not used for a long time, it is good practice to unplug it from the mains (at
the magnetothermal safety switch upstream from the appliance) and to turn off the water with
the cut-of cock on the main supply line. It should be carefully cleaned inside the cooking
chamber and outside, taking special care to remove any salt deposits which would cause
corrosion to the steel surfaces. We also advise protecting the appliance with an oily base spray
(e.g. Vaseline oil), which forms an effective protective film on the surface of the steel. A suitable
covering would also protect the appliance from the dust.
10. Maintenance
10.1 General information
A periodic control (at least once a year) of the appliance aids to guarantee long life and correct
operations. Any sort of maintenance work on the appliance must be done exclusively by
technically qualified operators who have been trained in the maintenance work on this
appliance. Before beginning any sort of maintenance work on the appliance, turn the power
supply off (at the magnetothermal safety switch upstream from the appliance) and let it cool
down. Access is gained to the inside components that could require maintenance work by
removing the left side of the appliance.
10.2 Door gasket replacement
The door gasket has a rigid profile with retainer fins. This profile must be inserted in the suitable
guide on the front of the cooking chamber.
To replace the gasket just remove the worn one from the guide (pull hard at the 4 corners).
Clean the guide from any dirt and insert the new gasket (it is advisable to moisten the gasket
profile with soapy water to make fitting easier).
