Tecno-gaz EkstraPLUS PT002TTM, Инструкция по эксплуатации

Страница: 58 / 164

ENGLISH
24
7.6 Display during the cycle
As previously mentioned, after performing the following steps:
a)
Inserting the instruments
b)
Closing the door
c)
Selecting the stations and type of cycle
The cycle is launched by pressing the START button.

Since the treatment, as previously shown in Fig.20 and Fig.22, is applied to individual
channel types
it is possible to inhibit the treatment of water/spray channels, for the treatment of tools
that do not have connections for water/spray cooling channels integrated in the quick
connection:
Prolonged pressing (3 seconds) of the button
of the machine to which the tool is connected
generates the message of video "J" (e.g.
Machine 2);
- it is possible to exit without changing the
setting or you can confirm your choice with OK;
- If the change is confirmed, the LED of the
machine flashes to indicate the different setting
- Pressing the button of the modified machine
resets the settings
COMPLETE / EKSTRA CYCLE:
The cycle is performed according to the sequence of the steps listed below and shown on the
display.
TYPE OF CYCLE
COMPLETE
PHASE 2 CLEAN
SCREEN B1-2
TYPE OF CYCLE
COMPLETE
PHASE 3 BLEED
SCREEN B1-3
TYPE OF CYCLE
COMPLETE
PHASE 4 LUBRICATION
SCREEN B1-4
TYPE OF CYCLE
COMPLETE
PHASE 5 BLEED
SCREEN B1-5
TYPE OF CYCLE
COMPLETE
FINISHED CYCLE
SCREEN B1-6
OK
DD-MM-AA hh-mm
DD-MM-AA hh-mm
DD-MM-AA hh-mm DD-MM-AA hh-mm
DD-MM-AA hh-mm DD-MM-AA hh-mm DD-MM-AA hh-mm
TYPE OF CYCLE
COMPLETE
PHASE 1 BLEED
SCREEN B1-1
DO YOU WANT TO EXCLUDE
THE TREATMENT FOR
WATER AND SPRAY PIPES
P2 ?
P2 (
3
s)
J
EXIT