Tecno Air System RUBY, Руководство по эксплуатации

Страница: 18 / 28

TecnoAirSystem
E s s e g e G r o u p
4.
INSTALLATION
UNPACKING
• Open the carton, making sure do not damage the appliance with sharp tools,
• Gently pull up the stove out from the packing beware to the glass,
• remove all protections and packing materials before using the stove and make sure that you have removed all
the accessories inside: feet, instruction manual, pump, lighter, and remove all the adhesives tapes and
packaging components that are inside the stove.
INSTALLATION
• After unpacking the appliance, place it in a secure and stable position that has been awarded , making sure
that there is enough space for the preliminaries.
• Make sure to place the stove in a right position to avoid possible impacts.
The stove do not requires chimney, anyway the room must be ventilated for a few minutes each hour of
use. The stove must be installed in compliance with the following safety conditions:
-keep a minimum distance on the sides, in front of and above of 1m and 10 cm on the back by an average of
flammable materials;
-if the stove is installed on a floor that can be damaged, place in between a layer as protection of heat insulating
material;
Where it is not possible to comply with distances given above, it is necessary put in place technicals and buildings
measures to avoid any risk of fire.
This stove cannot be used in place tightly closed, or too small as campers, trailers, passenger cars, boats...
REMOVABLE TANK YES
ADJUSTABLE FEET YES
LIGHTER YES
MANUAL PUMP TRANSFER YES
WARRANTY 2 YEARS
• Place the components as in
figure. A letting the screw to
the concave side of the
magneto
Screw the feet into right
mounting holes at the
basement of the stove
Pull the rod pulling to the botton
and insert it in its seat. READ AND
TAKE OUT THE PICTOGRAMS
STICKER ON THE BURNER
Do not use gasoline, diesel fuel, solvents or other fuels.
Use of an improper fuel may cause explosion and fire.
Ethaline the high quality bio-ethanol