Tecno Air System RUBY, Руководство по эксплуатации

Страница: 22 / 28

TecnoAirSystem
E s s e g e G r o u p
6.
TURNING OFF THE STOVE
To turn off the stove it is sufficiently slide inward the regulation rod (c) until the flame is extinguished. Do not
light again the stove right after turning it off. Wait until it cools down.
Always ensure that the flame is turned off/extinguished before leaving or staying asleep.
Warning: do not extinguish the flame with water or blowing up!
When the stove is off or when it is not in use, keep always closed the fuel tank through the suitable regulator.
If the stove turn off automatically you must close the tank with the regulation rod (c).
7.
STOVE CLEANING AND STORAGE
Keep clean from dust all surfaces of the stove and using a damp cloth . To clean the glass using a damp cloth or
a specific products for glass.
Keep clean all the internal parts of the stove . And it is advisable to periodically clean the tank during the season
of use the stove (if you do not use the stove for a long time or during the summer keep empty the tank) leaving
completely burn the fuel, wait for the stove become cool and remove the tank. Clean off any combustion
residues with a damp cloth (use of a hand protection gloves for maintenance work ), put it back into the place
.All maintenance operations must be performed with the stove off and well cooled. keep the stove clean and
dry.
8.
GUIDE TO SOLVE SMALL PROBLEMS
The stove will not start:
– verify that the lighter work properly, the bioethanol level is too low and lighter not get to fire;
– check the fuel level;
– fuel is not suitable.
Smoke comes out:
– fuel is not suitable, or extraneous flammable material presence inside the tank or in the stove.
Flame extinguishes:
– fuel not sufficient; fulfill the tank up to indicated level
– regulation flame door too close.
Flame spreads outside the tank:
– overfilling of the tank, the liquid is leaking, turn off the stove with regulator slider and allow remaining flames to
exhaust. Wait for the stove to cool and then turn on.
The tank become black:
– It is normal, could happen because the heat and the flame touch the metal. Wait until the fireplace become
cool and clean the soot with a soft dampened cloth.
In case of damage and/or malfunction of the appliance, please refer to qualified service center only.