Sirio HH
Use and maintenance manual
Page 13 of 28
Instruction n°
192
- Rev.
02
of 06/07/2016
EN
Copyright © 2016 Tecmec S.r.l.
Translated from the original instructions
D
Place the basement approximately 40
- 50Cm from the wall.
Verify that the floor is as flat as
possible, in case of differences use the
adjustable feet.
If this procedure is not carried out, the result could lead to noise, malfunctions, abnormal wear
of moving parts, and pose risks to the end user.
E
Introduce the shaft with the joint in
the reducer seat / location.
F
Introduce the drive shaft in to the
gear placed on the shelf, and then in
to the reducer joint crossing the
plastic protections.
Tighten the grain / screw of the joint
with the supplied key.
Slide the protections between them,
until they go in contact with the
structure.
