Fusion color FC
Cod. 7116430005 v 1.1 IT/EN
EN
Connections:
The projector is fitted with a VDE chassis male connector and two XLR 5 Poles connectors for DMX IN and OUT signal (Fig.1)
Fig. 1
Power supply connection:
Supply: 100/240V 50/60Hz
Fuse: T 3.15 A 250 V
DMX connector:
1: GND (screen)
2: data –
3: data +
4: NC
5: NC
DMX IN
DMX OUT
Any modification to this luminaries, without authorization, is forbidden.
This lantern must be powered according to the voltage and frequency showed on its label (100/240V 50/0Hz). Connect the power cable
to the socket. We suggest to connect each projector to its own switch so that they can be individually switched on with a remote
control.
To remote control the projectors is required the use of a DMX512 control desk.
For the connection of signal use cable EIA rs-485 type: two core screened, 120
Ω
characteristic impedance, 22-24 AWG, low capacity, 1
XLR 5 poles MALE connector and 1 XLR 5 poles FEMALE connector.
To form a DMX chain, connect the DMX control desk to the first projector’s DMX IN, then from its DMX OUT to the DMX IN of the
second projector and so on.
For a correct functioning of the DMX signal, it is necessari to put a terminal into the DMX OUT of the last projector. This terminal is
made of 1 XLR MALE connector with a 120
Ω
resistance welded between PIN 2 and PIN 3.
Addressing of the projector
To control many Fusion Color individually, it is necessary to assign to each one a different DMX address , setting the starting channel
taking into consideration that one Stage Color books 7 channels (3 or 4 or 6 or 7 or 12 channels depending on the functioning mode
set).
For example, if we have 6 projectors, it will be necessary to set them on the channels 1, 8, 15, 22, 29, 36.
To set the DMX channel use buttons ‘UP’ or ‘DOWN’ until you can see ‘Address’ on the display , then press ‘ENTER’. Change the DMX
address using the ‘UP’ ‘DOWN’ keys and then press ‘ENTER’ to confirm. It is also possible to change the DMX address using the remote
controller DLC 900 (separately sold), acting as follows:
Address
00001
•
Connect the DLC900 to the DMX IN of the projector (or of the DMX chain).
•
Switch the device on, pushing the button “POWER ON”, high-placed on the right.
•
Enter the “DeviceList” menu, pushing ENTER.
•
Enter the “Stage 18C” item, pushing ENTER.
•
Select the projector You want to control, between St18C 1, St18C 2, ... St18C N (the projector selected will flash) then push
ENTER.
•
Select “RemoteCtrl” item and push ENTER.
•
Push ENTER again to change the DMX starting channel, using the indicators
/
to select the figure and the indicators
/
to change the value. Push ENTER to confirm or BACK to cancel.
Push BACK until You get to the main menu.
Pagina
9