Teclumen Fusion color FC, Руководство пользователя, Страница: 11 / 16

Fusion color FC
Cod. 7116430005 v 1.1 IT/EN
Description for ‘Service’ menu
To exit from ‘Service’ menu, press and hold ‘ENTER’ key for more than 5 seconds or press ‘LEFT’ and
‘RIGHT’ contemporaneously. The functions settings will be enabled when exit this menu.
Display Option Description
DmxAddr Sets DMX address
Press ‘ENTER’ to display the current DMX address. Change value using
‘LEFT’ and ‘RIGHT’ keys to select the digit and ‘ UP’ and ‘DOWN’ keys to
change value. Press ‘ENTER’ to confirm.
Temp Projector temperature
Press ‘ENTER’ to display the current projector temperature. Press ‘ENTER’
to exit.
Max Temp Max Projector temperature
Press ‘ENTER’ to display the maximum projector temperature from the last
time it was turned on. Press ‘ENTER’ to exit.
DmxSetup Setting of the DMX mode
Press ‘ENTER’, the display will show the current DMX mode. Using ‘UP and
‘DOWN’ keys, change the DMX mode and then press ‘ENTER’ to confirm.
To see all possible settings, see the ‘DMX description’ on page 6.
Defaults Reset to default settings
Press ‘ENTER’. Set the value to 1 to reset the settings to default. Press
‘ENTER’ to confirm.
Sw Vers Software version
Press ‘ENTER’ to display the firmware version of the projector. Press
‘ENTER’ to esc.
SerNum Projector’s serial number
Press ‘ENTER’ to display the serial number of the projector. Press ‘ENTER’
to esc.
CalibRed calibration of Red
Sets the maximum level for Red
CalibGrn calibration of Green
Sets the maximum level for Green
CalibBlu Calibration of Blue
Sets the maximum level for Blue
SmoothDn Dimming mode
Press ‘ENTER’ to display the current dimming mode. Change the value
using the ‘UP or ‘DOWN’ keys then press ‘ENTER’ to confirm. If the value
is 0, the dimming will be quick and nervous. If the value is 1, the dimming
will be soft.
EN
This projector can be remote controlled by DLC900 in this way:
•
Connect the DLC900 to the DMX IN of the projector (or of the DMX chain).
• Switch the device on, pushing the button “POWER ON”, high-placed on the right.
•
Enter the “DeviceList” menu, pushing ENTER.
• Enter the “Stage 18C” item, pushing ENTER.
• Select the projector You want to control, between St18C 1, St18C 2, ... St18C N (the projector selected will flash) then push
ENTER.
• Select “RemoteCtrl” item and push ENTER
At this point you will see the ‘Service’ menu like in the table.
Pagina
11