User Manual
23
5.2.6.2 PTZ Set
Click [Main Menu
Device
PTZ] to enter into the below window shown as Picture 5-47.
5.2.6.3 Serial Set
Enter into the [Main menu
Device
Serial Set] interface shown as Picture 5-48.
5.2.7 System
5.2.7.1 General
Click [Main Menu
System
General] to enter into the interface shown as Picture 5-49
You will be allowed to modify system date/time,
date/time format, time zone, language, video format and
menu time out.
And click [DST Setup] button to enter into the below
interface shown as Picture 5-50, and you are allow to
configure DST status and mode.
Click [NTP setup] to enter into the interface shown
as Picture 5-51 and now allow you enable/disable
the NTP function.
When operate DVR via keyboard, it is required to set
communication protocol.
Baud rate:
set baud rate of serial communication.
Data bit:
set data bit of serial communication.
Stop bit:
set stop bit.
Parity Check:
set parity check to <None> or other.
You could select the channel you desire to
control and set PTZ protocol (Pelco-D or Pelco-P),
Baud Rate (1200, 2400, 4800, 9600), Data bit (8, 7,
6, 5), Stop bit (1, 2), Parity Check (None, Odd,
Even, Mark, Space), Address Code and Cruise
status respectively. Please note the PTZ device
can be activated only when a channel in
connection with the PTZ camera is selected.
Picture 5-47
Picture 5-48
Picture 5-49
