1
2
ELECTRICIAN INSTALLED SERIES
TH892-E: Power Point & Remote Controller Only
TH892-BTE: Bluetooth enabled Power Point
and Remote Control
INSTALLATION
WARNING:
The TH892-E/BTE must only be installed by a licenced electrician.
Do not exceed 10AMP total. Allow 600mm clearing from the ground or wet surface
THE REMOTE
Selected
Channel On
All Channels Off
Channels 1-6
Selected
Channel Off
Change Channel
ADDING A FIRST REMOTE
1.
Select Channel 1 on the
remote by using the
select button.
2.
Insert a paperclip into
the learn hole on the back of
the remote (Next to the screw)
3.
The Power Point will beep
four (4) times to indicate
successful pairing.
ALL ON/OFF FUNCTION
DELETE ALL REMOTES
Swipe BACK of remote to the
right-hand side of the Power Point
to turn ON or OFF both Power Points
1.
Select channel 1 by pressing
“Select” on both the master and
secondary remotes.
2.
Insert a paper clip pin into
the reset hole at the back of
the master remote.
3.
The power point will begin
to beep. Press the ‘ON’ (^)
button on the second remote.
ADDING A SECOND REMOTE TO THE POWER POINT
4.
The Power Point will beep
four (4) times to indicate
successful pairing.
S
S
M
M
M
= Master Controller (already Paired)
S
= Second Remote (to be paired)
M
S
1.
Ensure the remote is
already learned to power
point 1 and all remotes
have been deleted from
power point 2.
2.
Isolate power point 1 by cutting
the power from the mains (or
disconnecting from the wall).
PAIRING TWO POWERPOINTS TO ONE REMOTE
OFF
ON
1
2
3.
Select Channel 3 on the
remote by using the “select”
button.
4.
Insert a paper clip pin into
the reset hole at the back of
the remote.
5.
The Power Point will beep
four (4) times to indicate
successful pairing.
2
DIY INSTALLED SERIES
TH892: Power Point & Remote Controller Only
TH892-BT: Bluetooth enabled Power Point
and Remote Control
10
sec
1.
Hold the back of the remote
to the right hand side of the power
point 10 seconds.
2.
The powerpoint will have a
continuous tone then beep 4 times
to indicate completion of deletion.
