Instruction Manual - PH Slimline
Feel good through warmth from electricity - www.technotherm.de
GB
|9
9. INSTALLATION
• BEFORE INSTALLING
Whilst the installation of this heater is straightforward, please ensure you read the following carefully as
the manufacturer will not be liable for any damage or problems arising from incorrect installation.
Unwrap your heater and clear the packaging away. The packaging has been specifically chosen to allow
you to recycle it. If on unpacking, you discover any damage whatsoever, please get in touch with your sup
-
plier within 24 hours and prior to installation.
For assembly and installation, please follow the instructions as set out in this booklet. For safety reasons,
this heater should never be installed in close proximity to a bath or shower i.e. that you could touch the
controls whilst in the bath or shower. The radiator should not be placed below a socket. If the cable has
been damaged, it can only be replaced by the manufacturer, through its aftersales team, or by a qualified
person. This ensures the user will not be in any danger. At the end of the manual, you will find a Guarantee,
please check that this has been completed correctly, dated and stamped
Very important:
- Read installation manual prior to installation of this unit!
- Read user manual before putting this unit in operation!
- Observe the warnings in the manuals!
- The installation room must fulfil the ventilation requirements!
- Installation by an authorised person only!
• CONNECTING ELECTRICITY SUPPLY
- If the Thermal Emitter that you have acquired does not have a plug on the supply cord, installati
on shouldbe carried out by a qualified electrician.
- Means for disconnection must be incorporated in the fixed wiring in accordance with the wiring
rules of thecountry where it is to be installed.
- Before connecting, check the supply is switched off.
- Before connecting the appliance to the fixed wiring check that the voltage of supply is inside the
ratedvalues indicated in the marking plate 220 - 240V.
- The appliance must be connected to the fused system of fixed wiring.
- Any problem arising from not following the instructions above will invalidate your guarantee
- When wiring up, please follow the colours of wires.
• HANGING THE HEATER
The radiator comes complete with an installation kit, comprising the following:
- Screws
- Brackets
Cardboard guide, (remove from the top of the box the radiator comes in). Please follow the illustrated
steps below to hang and install your radiator:
1.
Take the radiator out of its packaging and choose where to hang it. Please notethe minimum
distances required around the heater.
2.
Remove the cardboard guide from the lid of the box and place it at the rightheight, as shown
in diagram 4 below. We suggest you use a level to ensure theradiator is hung square. Using the
holes as your guide, mark where the bracketsneed to go.
3.
Drill and plug the holes.
4.
Screw the brackets to hold the radiator into place, using the screws and washersprovided.
5.
Place the unit so that the brackets [15] fit into the slot that has the upper profile ofthe radiator.
6.
Approximate the radiator to the holders of the wall brackets and screw fixation.
7.
Use a hole drill for holes with appropriate stoppers for the type of wall.
