Mini-Line G198 operating manual
Page 5
Note
Techniques to adjust the screed manually may vary from machine to machine.
Please refer to screed or/and paving machine manual regarding manual
adjustment of screed.
Note
The Null Position has been set by default at 144 mm from shaft mid- point to
reference beam or ground.
Note
A quick phasing check can be performed by lifting the Sensing Arm (by hand)
and observe a downward movement on the appropriate cylinder.
Note
LED indicators provide visual indication of screed angle of attack, thus mat
thickness. See table below for LED explanatory notes.
LED indicator
Angle of attack
1.
Top LED blinking (quick)
No change (out of range; too low)
2.
Top LED constantly ON
Increases (high pace)
3.
Top LED blinking (slow)
Increases (low pace)
4.
Top and Bottom LED OFF
No change (on target)
5.
Bottom LED blinking (slow)
Decreases (low pace)
6.
Bottom LED constantly ON
Decreases (high pace)
7.
Bottom LED blinking (quick)
No change (out of range)
Safety Instructions
Connections to power supply must be performed in accordance with safety instructions for
electrical facilities and performed only by trained operators. The equipment is NOT for use with
240 vAC mains or in conditions where temperature exceeds 80°C. If the equipment is used in a
manner not specified by TF-Technologies the protection provided by the equipment may be
impaired
Asphalt Paver Requirements
A pre-condition for the safe use of Mini-Line® Grade Control System in accordance with applicable
safety regulations is that the system is only used on asphalt pavers that comply with the applicable
safety regulation. The key safety requirements of asphalt pavers which have an influence on the
safe use of the Mini-Line® Grade Control System are therefore outlined below.
Key safety requirements of asphalt pavers for the safe use of Mini- Line® Grade Control
System
The asphalt paver must comply with the requirements described in EN 60204 Safety on Machinery -
Electrical equipment of Machines or similar, and in the EU be CE marked.
The asphalt paver must be equipped with an emergency stop that can stop all potentially dangerous
parts of the machine, including switching off the power supply to the Mini-Line® Grade Control
System.
The asphalt paver must stop all potentially dangerous parts of the machine in case of a malfunction
in the power supply, including switching off the power supply to the Mini-Line® Grade Control
System.
The Mini-Line® Grade Control System is developed for use on asphalt pavers with a 12V system
and asphalt pavers with a 24V system.
The asphalt paver must be able to deliver a stable power supply as described in EN 60204, for
instance via the battery of the asphalt paver.
Key safety requirements for safe installation of Mini-Line® Grade Control System
The Mini-Line® G198 Grade Control System must be installed, mounted and connected in
accordance with the instructions in this user manual.
