●
If you are taking a meas urement in an area in which you can not read the display, press the
button
to freeze the result on the display. The displ ay will then also show the lock symbol.
●
Press the
button again to take another measurement.
If you have completed your measurement, switch the moisture measuring device off with the
button. Then reattach the protective cap.
Note:
The moisture measuring device switches itself off automatically if the device is not
used for 60 seconds.
Battery display
●
If the battery charge status is low, the battery symbol
appears on the display
(7) .
Replace the battery as quickly as possible if this symbol appears. Empty batteries can
falsify the measured result. The battery change is described in the section
“Inserting/changing the battery
“
.Temperature display
●
You can change the temperat ure display bet ween
°
C and
°
F by holding down the
button (4) for approximately 5 seconds.
Troubleshooting
Error
Possible causes and solutions
The measurement is
obviously too high or low.
Check whether the device is set to the correct material.
Check if the measuring pins (2) are correctly pressed against
the material.
Repeat the measurement process.
The display (7) is reading
'Lo' or 'Hi'.
The measurement range has been exceeded or you have not
reached the measuring range.
The number on the display
is not reacting.
Is the lock key on the display Press the
button (4).
You can barely see the
number on the display.
The battery is low. See the chapter 'Inserting/ changing the
battery'.
Electrostatic discharges can lead to malfunctions. In the event of such malfunctions, remove
the batteries briefly and reinsert them.
Cleaning and Care
●
Do not allow liquids to enter the device. Otherwis e the product may be damaged.
●
Only clean the device with a slightly dampened cloth.
