Technogym Skillmill Console, Техническое обслуживание руководство

Страница: 28 / 76

Skillmill
Technical Service Guide - Rev. 2.2
Page 28 e-mail: support@technogym.com
3.1.6 ANGLE SENSOR
This is a potentiometer installed on the axis of the magnetic brake.
Is supplies the Low Kit with the position of the brake: from 0 to 10.
It supplies the Low Kit with the angular position of the brake. However, it is not possible to meas-
ure the correctness of this signal with a tester to check if the board functions. If correctly config-
ured, the Low Kit knows the relative resistance based on the angular position of the brake, and
by combining this information with the horizontal speed, the power developed by the customer is
calculated.
Functions with a power supply equal to 3 Vdc received from the Low Kit.
Each time the angle sensor is replaced or the components that make up the braking system are
replaced mechanically, the brake must be calibrated.
3.1.7 BATTERY (CONSOLE VERSION)
The battery replaces the external power supply, supplying power to the different electronic com-
ponents of the equipment. The battery charger is the same power supply used for the Connect
equipment. It is a power supply that supplies 5 Vdc and 2.0 A max.
The battery is connected to the Low Kit and through it, supplies power to the various equipment
components: display, angle sensor and RPM sensor.
It is necessary to recharge the battery every 60 - 90 days based on equipment use.
The battery lasts 90 days with 4 hours of equipment operation per day.
When the equipment is delivered, the battery charge level is between 40% and 60%. Before starting
the equipment, completely charge the battery using the specific power supply.