Technogym Run XT, Руководство по техническому обслуживанию

Страница: 99 / 132

RUN XT: Service & Maintenance Manual - rev. 2.0
Page 8.1
8. ADJUSTMENTS
8.1. TENSIONING A NEW TREAD BELT
Figure 8.1-1
1. After assembling the new tread belt, tighten
the tread belt until it is just slightly taut.
2. Place a tape measure along the right hand
edge of the tread belt, and use a pen make
two reference marks on the tread belt at a
distance of exactly 1 meter from each other.
Figure 8.1-2
3. Lock down the right hand tread belt tensioner
screw
a until the distance between the
reference marks increases by 7 mm.
4. Lock down the left hand tread belt tensioner
screw until the driven roller is aligned with
the crosspiece.
After completing this procedure, any
further adjustments should be
performed using only the left-hand
tensioning screw.
After completing this procedure, check
the centering of the tread belt as
instructed in paragraph 8.3.