Technogym Run XT, Руководство по техническому обслуживанию

Страница: 29 / 132

RUN XT: Service & Maintenance Manual - rev. 2.0
Page 5.1
5. INSTALLATION INSTRUCTIONS
5.1. SPECIFICATIONS AND REQUIREMENTS
For correct machine installation, make sure that:
1. The machine is installed on a level surface that is free of vibrations and has sufficient carrying
capacity for the combined weight of the machine and user.
2. The environment is dust or sand free.
3. The environment meets the operating temperature and humidity conditions specified in paragraph
2.3. .
4. The machine is not positioned close to sources of heat, sources of electromagnetic noise
(television sets, electric motors, antennas, high voltage lines, appliances etc…) or medical
equipment.
5. To eliminate any interference with the cardio receiver, there should not be any transmitters at a
distance of 100 cm from the display.
6. The mains voltage must match the value specified on the machine rating plate.
7. The electrical system must be provided with an efficient ground connection.
8. The wall outlet used should be reserved for the machine and have a rating of at least 1800 Watt.
9. Do not connect other machines or users to the same wall outlet.
10. Position the mains lead of the machine where is will not be underfoot. For this purpose, it is
recommended to use the special trackways supplied with the machine.
5.2. INSTALLATION
To correctly install the machine, proceed as follows:
1. Ensure that the specifications and requirements for installation have been met (see paragraph 5.1.
).
2. Remove the machine from its packing materials: one carton fixed to a wooden pallet for overseas
shipment, one nylon bag for Italy. For machines shipped in cartons, the side uprights and handles
are disassembled and placed on the tread belt.
3. Position the machine as specified above, on a level surface that is free of vibrations and has
sufficient carrying capacity for the combined weight of the machine and the user.
4. For machines which shipped in a carton, it is necessary to reassemble the components that were
disassembled for transport. Follow the procedure for assembling the side uprights and handles
described in the "Operating and service instructions" supplied with each machine.
5. Connect the mains lead to the inlet socket on the machine.
6. Place the on/off switch in the “0” position.
7. Plug the mains lead into the electrical outlet.