Technisonic Industries Limited TiL-90-6R/8.33, Инструкция по установке и эксплуатации

Страница: 11 / 45

2-2
(2) Screw transceiver to the mounting bracket using the two wing screws and nylon
washers included in Mounting Hardware kit, Part Number 869024-1.
(3) Adjust angle of transceiver on nylon clutches as required, before tightening the two
wing screws.
2.3 OPTIONAL LOUDSPEAKER, HEADPHONE INSTALLATION
Provision is made for connection of an external loudspeaker or headphone to the
SPEAKER/PHONE jack of the transceiver, as shown in Figure 4-1.
2.3.1 External Loudspeaker
When an external loudspeaker is to be installed, an 8-ohm nominal impedance loudspeaker should
be used. The loudspeaker cable should be terminated by a 1/4 in., 3-pole telephone plug (male), with
the loudspeaker connected between tip and sleeve (ground). Insert the external loudspeaker
connector into the SPEAKER/PHONE jack located on the front panel of the transceiver. When the
external loudspeaker is connected to the transceiver SPEAKER/PHONE jack, the internal
loudspeaker is automatically disconnected.
2.3.2 Headset
Headset impedance should be 150 to 600 ohms. The headset cable must terminate in a 1/4
in., 3-pole telephone plug (male), to mate with the SPEAKER/PHONE jack located on the front
panel of the transceiver. The internal loudspeaker is automatically disconnected. Connect the
headset as indicated below for receiver audio with or without transmit audio.
(1) HEADSET WITHOUT TRANSMIT AUDIO - When receiver audio only without transmit
audio is required, the headset should be connected between the tip and sleeve (ground)
of the telephone plug.
(2) HEADSET WITH TRANSMIT AUDIO - When receiver audio with transmit audio is
required, the headset should be connected between the ring and sleeve (ground).
2.4 OPERATIONAL CHECK
Perform an operational check of the transceiver after all adjustments. Check each channel in use in
both the transmit and receive modes of operation, using the Operating Instructions given in Section
3 of this document and the appropriate specified operating procedures during transmission.
2.5 STORAGE
To store for an extended period, store unit in a dry place, in the original shipping container.