Technisonic Industries Limited TiL-90-6R/8.33, Инструкция по установке и эксплуатации

Страница: 10 / 45

2-1
SECTION 2
PREPARATION FOR USE AND STORAGE
2.1 INTRODUCTION
This section provides the information required for use and storage of the low cost base station.
Refer to Section 4 for Channel/Frequency configuration.
2.2 DISASSEMBLY/ASSEMBLY
2.2.1 Remove Replace Microphone
REMOVAL
(1) Disconnect microphone from front panel of transceiver. Slide microphone clear of
bracket.
(2) Remove and Retain two screws securing microphone bracket to the side of the SPG-
010 Power Supply/Battery Charger.
REPLACEMENT
(1) Secure microphone bracket to left or right side of the SPG-010 Power Supply/Battery
Charger as required, with two screws and two washers.
(2) Connect microphone to front panel connector on transceiver. Slide microphone onto
bracket.
2.2.2 Remove/Replace Transceiver Unit
REMOVAL
(1) Disconnect the DC cable and RF antenna cable from the appropriate connectors located
at the rear of the transceiver.
(2) Remove and retain the two wing screw and nylon washers securing the transceiver to
the "U" shaped mounting bracket located on the SPG-010 chassis.
(3) Slide the transceiver upward to clear the "U" shaped mounting bracket.
REPLACEMENT
(1) Slide the transceiver downward into the mounting bracket, aligning the mounting bracket
holes with the threaded transceiver mounting holes.