TECHNISONIC INDUSTRIES LIMITED
www.til.ca
TFM-30 Installation & Operating Instructions
TiL 98RE244 Rev n/c Issue 9
3-1
SECTION 3 – INSTALLATION INSTRUCTIONS
3.1 GENERAL
This section contains information and instructions for the correct installation of the TFM-30,
VHF/FM Transceiver.
Make certain that the correct frequencies are pre-programmed in accordance with the
equipment user's valid FCC operator's license, prior to installation.
3.2 EQUIPMENT PACKING LOG
Unpack the equipment and check for any damage that may have occurred during transit.
Save the original shipping container for returns due to damage or warranty claims. Check
that each item on the packing slip has been shipped in the container. Verify that the
equipment display and backlighting configuration are the same as those ordered.
3.3 TRANSCEIVER INSTALLATION
The TFM-30 series Transceivers are designed to be Dzus mounted and should be installed in
conjunction with an IN-30 installation kit. See FIGURE 3-1 for an outline drawing of the unit
with dimensions to facilitate the installation.
3.4 INSTALLATION KIT - CONTENTS
The IN-30 installation kit consists of:
1.
One 15-pin (female) and one 9-pin (male) Cannon D mating connector complete with
crimp pins and hoods.
2.
One BNC antenna mating RF connector (male) and hood.
3.5 ANTENNA INSTALLATION
The antenna should be mounted on the bottom of the aircraft whenever possible. Consult
with instructions provided with the antenna. Connect RF cable from antenna to the back of
the TFM-30 unit by utilizing the BNC mating connector provided in the installation kit.
3.6 INSTALLATION - PIN LOCATIONS AND CONNECTIONS
The pin numbers and locations for the 15- and 9-pin Cannon D-connectors located on the
rear of the TFM-30 transceiver are shown below. Pin connections are provided in TABLES
3-1 and 3-2.
FIGURE 3
Transceiver mounted view of 15-pin male and 9-pin female connector