TECHNISONIC INDUSTRIES LIMITED
www.til.ca
TFM-30 Installation & Operating Instructions
TiL 98RE244 Rev n/c Issue 9
2-7
2.13 PROGRAMMING CTCSS TONES/DPL CODES
CTCSS tones (PL tones) or Digital DPL codes can be assigned to each memory channel. The
guard receiver squelch will operate only on carrier detection, but guard 1 and 2 transmit
tones or codes can be programmed. To program a tone/code to a memory channel:
1.
Use the
M.UP
and
M.DN
keys to select the memory channel that you want to assign
a CTCSS tone or DPL code.
2.
Press the
FUNC
key then the
TONE
key. The display will show "RX TONE:" and the
current tone number,
as well as the tone frequency in Hz
.
3.
Use the
M.UP
and
M.DN
keys to select the tone number you require. The following
is a list of the available CTCSS tones:
Number Tone Number Tone Number Tone
01 67.0
26 162.2
51 177.3*
02 71.9
27 167.9
52 183.5*
03 74.4
28 173.8
53 189.9*
04 77.0
29 179.9
54 196.6*
05 79.7
30 186.2
55 199.5*
06 82.5
31 192.8
56 206.5*
07 85.4
32 203.5
57 210.7*
08 88.5
33 33.0*
58 218.1*
09 91.5
34 35.4*
59 225.7*
10 94.8
35 36.6*
60 229.1*
11 97.4
36 37.9*
61 233.6*
12 100.0
37 39.6*
62 241.8*
13 103.5
38 44.4*
63 250.3*
14 107.2
39 47.5*
64 No
Tone
15 110.9
40 49.2* (carrier
squelch
only)
16
114.8 41
51.2*
17
118.8 42
53.0*
18
123.0 43
54.9*
19
127.3 44
56.8*
20
131.8 45
58.8*
21 136.5
46 63.0*
22 141.3
47 69.4*
23 146.2
48 159.8*
24 151.4
49 165.5*
25 156.7
50 171.3*
TABLE 2.1
Available CTCSS tones
NOTE: The tones marked with * are non-standard tones.
4.
Press ENTER. "TX TONE" appears on the display. Repeat step 3.
5.
Press ENTER. "G1 TONE" appears on the display. Repeat step 3.
6.
Press ENTER. "G2 TONE" appears on the display. Repeat step 3 and press ENTER.
