Technische Alternative RAS PLUS DL, Инструкция по эксплуатации, программированию и установке

Страница: 26 / 28

26
The signal reported at the controller corresponds to the room temperature changed using the
rotary knob. The following signals are forwarded to the controller according to the switch
setting:
•
Automatic mode = Room tempe/- inverse rotary knob
•
Normal mode = Room tempe 50°C +/- inverse rotary knob
•
Lowering mode = Room tempe 100°C +/- inverse rotary knob
•
Standby mode = Room tempe 150°C +/- inverse rotary knob
The increased values for normal, lowering or standby mode are interpreted internally in the
UVR63-H and in the heating circuit controller function module of the UVR1611. The display in
the measured values overview of the UVR1611 takes place without offset values of the oper-
ating mode switch.
Use as a remote control
If the installation location of the room sensor is unsuitable as a reference room, the room
sensor
RAS+DL can also be used merely as a remote control , by using Index 5 as the meas-
ured value. Using this method, a fixed value of 20°C with offset values of the +/- setting and
the slider switch are forwarded to the controller.
Room sensors with other controllers
In the controllers ESR31 (from version 1.0), ESR21, UVR61-3, UVR63 (from version 5.0) and
UVR63-H (version 5.0 up to 7.1), only the measured room temperature can be evaluated, i.e.
without offset values (index 2); the slider switch and the rotary knob have no purpose with
these controllers.
Key operation for the display values is as for the controller UVR1611.
Installation
The sensor can only be used in dry rooms and can be installed directly on a level surface or in
a standard device enclosure.
The room sensor must be opened for mounting. A small screwdriver is used to press in both
the clamps beneath the temperature selection knob and slider switch while simultaneously
raising the cover. The base plate can now be easily mounted.