TechniSat TECHNIPOLAR 2 S, Инструкция по эксплуатации

Страница: 49 / 80

49
DE
EN
PL
NL
10.3 Activities at the start / end of the season
Start of the season:
> Check the power cord and plug for damage. Check the basic installation of
the unit and the location according to these instructions.
End of the season:
If the air conditioner is not going to be used for an extended period:
> Empty the condensation collection container completely and leave the lower
drain cap open until the residual water has drained off. As soon as the tank is
completely empty and no more water drains out, replace the rubber stopper.
> Remove and clean the filter, let it dry completely and then reinsert it.
> Remove the batteries from the remote control.
> Store the air conditioner in a cool, dry place away from direct sunlight,
extreme temperatures and excessive dust.
11 Troubleshooting
Problem Cause Solution
The air conditioner does
not start / does not
switch on.
No power. Check the electrical
supply.
Power cord not plugged
in.
Plug the power cord into
a wall outlet.
Protection circuit
activated.
Wait 30 minutes and
then try again. If the
error persists, contact our
service department.
The air conditioner only
runs for a short time.
The exhaust hose is
kinked or incorrectly
connected.
Follow the steps in the
operating instructions for
connecting the exhaust
hose
The air outlet / exhaust
hose is blocked.
Check the air outlet /
exhaust hose for possible
dirt contamination.