Technika TFL7W, Руководство пользователя

Страница: 8 / 48

8
Appropriate Installation Location
Removing Packaging Reinforcement
Your washing machine automatically detects the amount of laundry placed inside when selecting a program.
While installing the product, before the first use, calibration should be done
to ensure that the laundry amount is detected in the most accurate way.
To do this, select the Drum Cleaning* program and cancel the spin function. Start the
program without laundry. Wait for the program to finish, which will take about 15 minutes.
*The program name may vary depending on the model. For the appropriate program selection, review the program
descriptions section.
• Preparation of the location and electrical, tap water and waste water
installations at the place of installation is under customer’s responsibility.
• Make sure that the water inlet and discharge hoses as well as the power cable are not folded,
pinched or crushed while pushing the product into its place after installation or cleaning procedures.
• Prior to installation, visually check if the product has any defects on it.
If so, do not have it installed. Damaged products cause risks for your safety.
INSTALLATION
• Place the product on a hard and level floor. Do not put it onto a carpet with high pile or other similar surfaces.
• When the washing machine and dryer are placed on top of each other, their total weight – when loaded –
amounts to 180 kg. Place the product on a solid and flat floor that has sufficient load carrying capacity!
• Do not place the product on the power cable.
• Do not install the product in the environments where the temperature falls below 0ºC.
• Leaving a gap at the sides of the machine is suggested to reduce vibration and noise
• On a graduated floor, do not place the product next to the edge or on a platform.
• Do not place heat sources such as Hobs, Irons, Ovens, etc.
on the washing machine and do not use them on the product.
Tilt the machine backwards to remove the packaging reinforcement.
Remove the packaging reinforcement by pulling the ribbon.
Do not make this operation alone by yourself.