9
GB
Drill
Drill
80 mm dia.
bell saw
a t t a c h m e n t
Inside
Inside
Outside
Outside
B
A
Wall
Wall
3.3 DRILLING THE HOLES FOR THE PIPES
(for pipes entering through the rear of the air handler)
• Using an 80 mm dia. bell saw attachment, drill a hole in the wall for the pipes.
C
A - Start drilling (at a slight
angle) from the inside.
B - Complete the drilling from
the outside, keeping to
the same angle.
C - Put in a plastic tube and adapt it to suit. Fix the trim
which is part of the equipment.
3.4 HOOKING OF THE INTERNAL UNIT
• Remove the foam packing-pieces in the baffle.
5 - 10 mm
Trim
Hooking
• Hook the air handler on the support
plate according to the sketch
opposite.
• Connect the water pipes (see § 4).
• Run in any electric cables (see § 4).
• Then, press on the bottom of the unit
in order to engage the bottom hooks
in the holes in the support plate.
• Remove the setting wheel in order to reveal the ther-
mostat cover fixing screw.
• Remove the cover.
• Fix the thermostat using 2 screws (dimensions in
accordance with sketch opposite).
POSITIONING THE THERMOSTAT
• Fixing height: approx. 1.50 m above the floor.
• Avoid draughts from doors and windows.
• Also make sure that the thermostat is in the premises'
normal convection currents, and that it is not fitted inside
shelving or covered by curtains.
• All unwanted heat sources adversely affect control; avoid
therefore sunlight, the proximity of supplementary
heaters, lights, chimneys, television sets, etc...
8
69
36
113
8,5
53,5
5
67
3.6 FIXING THE ROOM THERMOSTAT
3.5 UNHOOKING THE INTERNAL UNIT
• In order to unhook the unit from the support plate, push the unit upwards and pull
it towards you. The hooks are then released from the support plate.
80 mm dia.
bell saw
a t t a c h m e n t
