23
Installing Fixed Gobos
1. Remove fixtures Top cover to gain access to the Fixed Gobo Wheel.
2. Physically rotate the wheel to locate the desired gobo.
3. Gently push the Gobo Holder forward to release from the wheel then pull the holder
out of the wheel. Fixed Gobo positions can easily be swapped.
4. To reinsert the Gobo Holder: Slide the gobo holder under the Retaining Clip and press
into place. Make certain that the Gobo Holder seats flat into the Fixed Gobo Wheel.
5. To change the Gobo: With the Gobo Holder out of the fixture, remove the 3 screws
that clamp the gobo into the holder. If the gobo is a textured effect, install the smooth
side toward the lamp. If the gobo is a dichroic (glass litho), install with the coated side
away from the lamp. To find the coated side, place a pointed object such as a small
screw driver or pen against one side of the gobo. View at an angle such that the
reflection of the pointed object can be seen on the surface of the gobo. The reflection
will appear to meet the object on the coated side (place toward lamp) and on the
uncoated side there will appear to be a slight gap between the reflection and the
object.
6. Reassemble the gobo holder with the 3 screws. Be careful not to scratch the gobo.
7. Clean finger prints from the gobo using a soft lint free cloth or tissue and either
Isopropyl or Denatured Alcohol.
Gobo
Retaining Clip
Gobo Holder
Содержание IL-TRACKER250S/1
Страница 2: ...2 2005 Techni Lux Inc...
Страница 21: ...21 Photometric Charts...