INTRODUCTION
Thank you for using the XS, our moving head fixture completely manufactured in light alloy and plastic material, with an optic system
of incredible performance and a modern and reliable electronics, can be smartly used anywhere.
To make the most of its possibilites and for a correct functioning of this unit in the years to come, we suggest you to read carefully
this manual before connecting or putting the spot into use. By doing so you will gain experience with its commands and connections
and you will be easily able to use it.
YOUR REFERENCE
Always remember to give the serial number and to specify the model any time you address the seller for information or
assistance.
BASIC KIT
(all versions)
•Projector
•Power connector
•User’s manual
•Studio Due warranty
•Metal fixing plate
•Lamp (upon request)
AVAILABLE VERSIONS
art. 03061: XS1200 • art. 0306: XS700/B
SAFETY INFORMATION
READ ALL CAUTIONS AND WARNINGS PRIOR TO OPERATE THIS EQUIPMENT.
INSTRUCTION TO PREVENT INJURY OR DAMAGE DUE TO ELECTRIC SHOCK, FIRE, MECHANICAL HAZARDS AND
UV RADIATION HAZARDS.
•PROTECTION AGAINST FIRE
1) This equipments are designed for use with the following lamps:
HTI 1200 S XS (XS1200)
HTI 700 DE XS (XS1200)
HMP 575 DE XS (XS1200 and XS700/B)
USE COMPLETELY EQUIVALENT LAMPS ONLY!
2) Maintain minimum distance of 0.3 meter from walls or any other type of flammable surfaces.
3) Maintain minimum distance to lighted objects of 1.0 meter.
4) Replace fuses only with the specified type and rating.
5) Do not install the spot close to heat sources. Do not lay the connection cable on the spot when it is warm.
•PROTECTION AGAINST ELECTRIC SHOCK
1) This equipment must be earthed.
2) Class I equipment. The power supply cord includes a protective earthing conductor as part of the cord. See page 5, pict.1.
3) For connection to the mains supply proceed as pict.1 page 5.
4) Disconnect power before lamp's replacement or servicing as page 6 (service personnel).
5) Do not install the spot outdoor, directly exposed to the rain or moisture.
•PROTECTION AGAINST MECHANICAL HAZARDS
1) Use safety chain when fixing this equipment (page 4).
2) Hot lamp explosion hazard. Do not open the equipment for five minutes after switching off.
3) Equipment surface may reach temperature up to 85°C. Allow about five minutes before handling.
4) Replace the lamp if it is damaged or thermally deformed and, in any case, do not exceed the lamp’s life.
•PROTECTION AGAINST UV RADIATION HAZARDS
1) Do not start on this equipment without lamp enclosure or if the protection screens, or ultraviolet screens are damaged.
2) The protection screens, the lenses, or the ultraviolet filters must be replaced if they are visibly damaged and their effectiveness
has been reduced, for example, by cracks or deep scratches.
3) Do not look directly at the lamp while lamp is on.
WARNING
!
... 1 ...
Содержание HMI 1200W/S XS
Страница 26: ...25 TD XS700 B base PROVISIONAL...
Страница 27: ...26 TD XS700 B head PROVISIONAL...
Страница 28: ......