8
Model: TX-193 Article No. 4999, 05/2022
! Attention:
This compressor is designed to increase the tyre pressure, if you want to
decrease the tyre pressure you have to do this manually, e.g. at the valve.
Connect the air hose to the vent and press the
“
On/Off
”
button to start the Air-compressor.
The unit stops automatically if the selected pressure is reached.
Information:
The pressure indication in the display has an accuracy of ~ +/- 0.1 bar. The
display tolerance depends on various factors; depending on the intended use, the pressure
should be checked with a calibrated pressure tester.
Battery-Charger
Foreword
To protect the on-board electronics, the car battery can be disconnected before charging.
The correct sequence is important here: first unscrew the black - in some cases also blue -
cable from the negative terminal and only then remove the red cable from the positive
terminal.
All batteries have a limited service life that depends on how the battery is maintained,
among other things. Below 10.5 V a vehicle battery (lead battery) is regarded as exhaustively
discharged and may suffer irreversible damage if stored for a long period. The charger is
unable to charge batteries that are damaged or defective (e.g. cell short circuit).
The Battery charger was designed to load different types of Batteries like
•
WET (operates by means of a liquid electrolyte solution)
•
AGM (Absorbent Glass Mat)
•
GEL (lead-acid battery that is valve regulated)
The equipment must not be used for charging lithium iron phosphate rechargeable batteries
(e.g. LiFePO4) or other lithium rechargeable batteries.
The equipment is to be used only for its prescribed purpose. Any other use is deemed to be a
case of misuse. The user / operator and not the manufacturer will be liable for any damage
or injuries of any kind caused as a result of this.
Before starting the loading, process make sure the batterie type you chose correspond with
the batterie you load.
Charge a WET Battery:
•
Release or remove the battery stoppers (if fitted) from the battery.
•
Check the acid level in the battery. If necessary, top up the battery with distilled
water (if possible). Important! Battery acid is aggressive. Rinse off any acid splashes
thoroughly with lots of water and seek medical advice if necessary.
•
First connect the red charging cable to the positive (+) pole of the battery.
•
Then connect the black charging cable to the negative (-) pole of the battery.
•
Plug in the charger to mains
•
Select the battery type wet with the Enter button
•
Select the loading current with + or
–
button
•
Press On/Off button to start charging.
The display shows now the Voltage and the capacity of the battery. The Battery-charger stop
if the Battery is fully loaded.
