EMERGENCY STOP
Before beginning a workout session ensure that the Safety Tether Key is properly placed
onto the Computer Console and the Safety Clip is securely attached to an article of your
clothing. If you fall the clip will pull out the
SAFETY TETHER KEY
from the Computer
Console and the running belt will stop immediately for emergency stop, helping to prevent
injury.
Replaced the Safety Tether Key onto the Computer Console. Press the START button to
begin exercise again.
STEP 2
It is recommended to have a second person assist with this step. One person should hold
the Computer Console in place while the other person connects the cables.
Install the Handlebar Bracket onto the Right and Left Handlebar Support Tubes, Screw off two
Hexagon Socket Oval Head Bolts,two curved Washers on each side of support tubes. Tighten
bolts with the Allen Wrench provided.
Connect the Control Pad signal cable (A) from the right handlebar to the signal cable (B) on right
support tube.
SAFETY TETHER KEY
9
LUBRICATION
How to check running belt for proper lubrication
Lift one side of the running belt and feel the top surface of the running deck.
If the surface is slick to the touch, then no further lubrication is required
If the surface is dry to the touch, apply some lubricant.
Avoid over oiling the running deck.
Lubricating your treadmill running belt will ensure superior performance and extend its life expectan-
cy. When you receive your treadmill please apply some lubricant into each oil pipe. After the first 25
hours of use ( or 2-3 months ) apply some lubricant and repeat for every following 50 hours of use (
or 5-8 months).
