“Throttle-Tech” Users Manual
Copyright 2013 Tech-Aero Designs LLC
www.tech-aero.net
5
Figure 4
Connecting the Throttle-Tech Controller and LiPo Tap Boards
Use care when unplugging or plugging in the small JST connectors, grasping them only by their
plastic housing and never by the wires. The 3 wire throttle male connector plugs directly into the
receiver’s throttle channel and may be extended with an ordinary servo extension if needed. The 3
wire female connector goes to the ESC connector that would usually plug into the receiver throttle
channel. The controller board connects to the LiPo Tap board via the 2 wire connector as shown
in Figure 5 and Figure 6.
Repeat the previous 3 steps for the red ESC
battery and LiPo tap leads. It is recommended
that the finished ESC battery connections be
covered with color coded heat shrink tubing to
further protect the wiring and clearly identify
the proper battery connections.
