Battery and the Battery Charger slot are clean and undamaged and that the contacts are not bent.
2. Once charging commences, the Red LED will on.
3. When the Battery is fully charged, the Red LED will off and Green LED will on.
Battery Charge Level: The Battery has a built-in Battery Charge Indicator
Pressing on the button to the right will indicate the charge level. The right LED indicates a high
charge level and the left a low charge level that will mean the battery pack will require charging
soon.
MPORTANT: When a low charge level is indicated, the tool may stop operating while in use, which
is dangerous when operating a circular saw. Always ensure the battery pack has a good charge
level.
Note: about battery charging:
- The battery should be charged at ambient temperatures between 10 and 40°C (ideally around
20°C)
- After charging, allow 15 minutes for the battery to cool before use
- Ensure that the charger is disconnected from the mains supply after use, and is stored correctly
- DO NOT leave batteries on charge for extended periods and NEVER store batteries on charge
- The Battery Charger monitors battery temperature and voltage while charging. Remove the
Battery once charging is complete to maximise charge cycles of the battery and not waste power
- Batteries can become faulty over time, individual cells in the battery can fail and the battery
could short. The charger will not charge faulty batteries. Use another battery, if possible, to
check correct functionality of the charger and purchase a replacement battery if a faulty battery
is indicated
- DO NOT store lithium-ion battery packs in a discharged state over a long period as this can
damage the lithium-ion cells. For long-term storage, store batteries in a high charge state
disconnected from the power tool
- The capacity of batteries will reduce over time. After 100 charge cycles, the battery’s operation
time and the maximum torque performance of the driver will slightly reduce. This decline will
continue until the battery has minimal capacity after 250 charge cycles. This is normal and not a
fault with the battery pack
Fitting drill bits and accessories
WARNING:
ALWAYS remove the Battery from the drill before attaching, adjusting or removing
accessories.
WARNING:
DO NOT attempt to tighten drill bits (or any other accessory) by gripping the front part
of the chuck and switching the tool on. This can lead to personal injury and can cause damage to
the chuck
WARNING:
NEVER fit any accessory or bit with a maximum speed lower than the no load speed
of he power tool.
1. Open the Chuck by rotating the Chuck (1) anti-clockwise
2. Place the drill bit or accessory centrally into the chuck
9
- -
