3. Tighten the Chuck Jaws by rotating the Chuck Collar clockwise
4. When the drill bit or accessory is securely fastened,
carefully run the Machine to test that it is running centrally,
smoothly and evenly. If the bit is 'wobbling' or not running
centrally, release the chuck, check the accessory for damage,
correct its position, retighten and test again.
Operation
Direction control
WARNING:
NEVER change the direction of rotation while the tool is running. This may cause
permanent damage to the tool.
- The direction of rotation can be set using the Forward/Reverse Switch (5)
- For anti-clockwise rotation, push the switch to the right
- For clockwise rotation, push the switch to the left
Note: When the Forward/Reverse Switch is in the central position,
the drill is locked and cannot be switched on. Use this setting as
a safety feature to prevent the drill from being switched on
accidentally.
If the motor carbon brush showed sporadic spark during the use,
it is the normal phenomenon.
Torque control
Note: This cordless drill is equipped with a torque control clutch allowing the machine to be set to
the correct torque for the individual application.
- The clutch settings are indicated by the symbols on the
Torque Selector (2)
- Rotate the Torque Selector to select the desired
setting: the higher the number displayed on the
torque ring, the higher the torque produced by the too.
Gear selection
- Select gear 1 on the Gear Switch (3) for the higher torque. A lower speed gear is generally more
suitable for driving screws and fasteners
- Select gear 2 on the Gear Switch for the lower torque.
A higher speed gear is for drilling and must not be used
for driving screws and fasteners
TDHD01P
18V Hammer Drill /Driver Kit
5
10
- -
