3. DISASSEMBLY
AND
REASSEMBLY
EO18-13004
3.2 Disassembling the Main Body
3- 4
3.2.5 Removing the IF PCB Ass’y and Control PCB Ass’y
1. Remove the two ST-3x6 screws which secure the IF PCB ass’y to the bottom chassis SA.
2. Disconnect the IF PCB ass’y from the control PCB ass’y.
3. Remove the two ST-3x6 screws which secure the control PCB ass’y to the bottom chassis SA.
4. Remove the control PCB ass’y.
NOTE: Be sure to remove the IF PCB ass’y before removing the control PCB ass’y. Pulling the
control PCB ass’y to separate from the IF PCB ass’y could damage the power switch.
3.2.6 Removing the AC Adapter
1. Cut the cable band to release the AC adapter cable.
2. Lift the AC adapter to remove it from the power case SA.
3. Take out the AC adapter cable from the power case SA.
4. Pass the connector of the AC adapter cable through the hole in the bottom of the power case SA.
NOTE: When reassembling the AC adapter, install the AC adapter cable so that the ferrite core is
located about 200 mm from the end of the connector.
ST-3x6
Control PCB Ass’y
Bottom Chassis SA
ST-3x6
IF PCB Ass’y
Fig. 3-5
Fig. 3-6
Fig. 3-7
AC Adapter
AC Adapter Cable
Power Case SA
AC Adapter
Ferrite Core
Cable Band
200mm
120mm
