CAN-bus
3.2.2.
Forced vehicle recognition
Forced vehicle recognition is only to be executed in exceptional cases, when automatic
vehicle recognition has failed.
Programming is carried out via programming button and LED
indicator, which are located in the unit’s body. Prior to forced
vehicle recognition, the vehicle group previously
must not
have been identified (if the vehicle group has previously
already been identified, a factory reset is necessary) and the
CAN-bus
must not
be connected. Programming stops if the
programming button is not pressed within 60 seconds.
Programming sequence
of forced vehicle recognition:
1.
Connect the unit to power only and wait for permanent short fast light signals.
2.
Press and release the programming button 10 times (begin this action not later than
10 seconds upon connecting the power source to the unit). If all the actions are
carried out correctly, the unit confirms with three light signals.
3.
Enter option No. 1 – forced vehicle recognition (see table 2, chapter 4.1.) – by
pressing the programming button 1 time. The unit confirms the selection with
repeated single light signals.
4.
Enter vehicle group number by pressing the programming button for the
corresponding number of times (see vehicle-specific installation file for group
number). The unit periodically emits series of light signals, where the number of
signals corresponds with the entered group number.
5.
Wait at least 2 seconds.
6.
Enter the vehicle sub-group number by pressing the programming button for the
corresponding number of times (see vehicle-specific installation file for sub-group
number). Check if the vehicle model has been chosen correctly. The unit emits light
signals (group number – pause, sub-group number – pause):
•
If the vehicle model is chosen correctly, press the programming button once.
Light signals stop and the vehicle model is saved.
•
If the vehicle model has been chosen incorrectly, press the programming
button twice. Repeat the programming beginning from point 4.
7.
Reconnect unit to CAN-bus.
3.3.
Connections of programmable outputs/inputs
After successful vehicle recognition disconnect the unit’s black-box from its harness.
Connect all the input and output wires to the corresponding places. Make sure that
unneeded output/input wires are isolated.