TEAMWELDER Plasma CUT 105, Руководство пользователя

Страница: 55 / 64

User manual 55
Problems Cause/solution
The arc does not jump to the part on which
you are working.
Work clamp is not connected to the work
piece, the work clamp is broken, or there
is a wrong connection inside the mass
cable. Connect or repair the mass
clamp/cable.
Work clamp does not make good contact
metal.
Clean the area where the work piece.
Connect the work piece.
The torch is too far from the piece.
Bring the torch to the workpiece and start
again.
6. 6.1
6.2
6.3
7. The arc goes out, but comes back on when
the gun trigger is pulled.
7.1 Consumable parts are worn or damaged.
Check and replace consumable parts if
they are need. Check the consumables in
this section.
The gas pressure is incorrect.
Adjust the gas pressure. See Setting and
check gas pressure, section 4.
Check that the gas pressure in the power
supply is not less than 6.0 bar with a flow
of 200 l / min
The internal filter gas element is
contaminated.
Change the element - See Change the
filter element, in this section.
7.2
7.3
8. The arc sputters and hisses. 8.1 The gas filter element out of the power
source is contaminated.
Replace the filter element.
There is water in the air line.
Drain the filter bowl. See additional
filtration gas in section 3.
Consumables worn or improperly
installed.
Inspect the consumables. Replace if
necessary.
8.2
8.3
9. The cut quality is not good. 9.1 The consumables are worn or not
properly used.
See Inspection of consumables in this
section.
See Operation Torch, section 4.