TEAMWELDER Plasma CUT 105, Руководство пользователя

Страница: 42 / 64

User manual 42
Hand torch cutting technique
Torch jogging without reducing the life of the
nozzle and the electrode.
When cutting, make sure the sparks out of the
bottom of the piece.
If sparks will jump up to the part, it is because
you are moving the torch too fast or without
enough energy.
Hold the torch vertically and watch the arc while cutting along the line.
Unshielded consumables. Keep away from the torch to the work of about 4.0 mm.
Shielded consumables. Please don`t tighten down the torch to the work piece
while cutting. Slide the torch carefully along the work piece to obtain a perfect cut.
• Put the torch along the cut, is easier to drive.
•
For cutting thin material, reduce the amp to get a higher quality cut.
• For straight cuts, use a ruler as a guide. To cut circles, use a template ar circ-
le cutting attachment.
•
Post flow – After the switch is released the gun trigger, the gas will continue
to flow for 30 seconds to cool the torch and consumables.
Note: The torch will restart if you enable the trigger during post flow. To stop post
flow activate and quickly release the gun trigger.