Teamline 5141, Руководство по установке

Страница: 23 / 30

Teamline 5141 Installation Guide Page 22
Installing the VHD-V71 camera
Installing the VHD-V71 camera
Before you install the camera, read the following safety information:
n
Do not subject the camera to rain or moisture
n
To prevent electric shock, do not remove screws or covers of the camera.
There are no self-serviceable parts. Refer to qualified service personnel for
servicing
n
Do not operate under unspecified temperature, humidity or power supply
n
Use the soft dry cloth to clean the camera. If the camera is very dirty, clean it
with diluted neutral detergent; do not use any type of solvent, which may
damage the surface
n
The installation must be performed by qualified service personnel or system
installers in accordance with all local rules
n
Do not move the camera head manually. Doing so results in the camera
malfunctioning
n
Before powering the camera, check the power voltage carefully. Ensure you
are using the correct power source
n
Ensure that the camera is far away from areas where there might be
radiation, x-rays, or strong electric waves, or where magnetism is
generated
To install the camera:
1. Connect the supplied USB cable to the USB connector on the camera.
Connect the other end to the Camera In USB connector on the Teamline
system.
2. Connect power to the DC 12V power input connector on the back of the
camera.
Microphone selection, placement, and setup
Teamline systems provide class-leading super-wideband audio to rooms of
all sizes; however, to ensure this audio performance, you must use the correct
number of microphones in the correct places for a given room. This topic helps
you to configure your microphone(s) with the Teamline system.
The 5141 system is shipped with a StarLeaf microphone. If required, a second
StarLeaf microphone can be connected to the Teamline 5141 system.
Features include:
n
Omni-directional pick up pattern
n
80Hz - 16kHz frequency response
n
> 70dB signal-to-noise ratio
n
Boundary mode operation