Team SILK FXB630, Инструкция по эксплуатации

Страница: 38 / 76

FXB630 Flange Facing and Grooving Machine
37
SECTION 7 MAINTENANCE INSTRUCTIONS
7.1 INTRODUCTION
The following information sets out recommendations for the maintenance of this equipment.
Periodic maintenance, when carried out as specified, will help to prevent premature failure of
the equipment. Should a component fail or its operation become suspect the equipment
should not be used until the fault has been rectified.
7.2 PERIODIC MAINTENANCE
The following maintenance tasks are those required to help prevent premature failure of the
equipment. It is recommended that all the tasks should be carried out when specified.
PERIOD TASK
Daily when in use or on
completion of a job
Clean the equipment.
Check all components are present (refer to packing
list in Section 5.2.1) and in good working order.
Check for correct operation of all the control devices.
Check all fasteners are properly tight.
Grind the cutting tools
Wipe all components with a small quantity of light
machine oil
Weekly when in use Complete the daily tasks.
Check adjustment of mast main bearing. Grease and
adjust. A slight pre-load on the bearing is required
(20 ftlbs, 27 Nm)
Check the drive motor bearings, gears and vanes for
wear/damage – see manufacturer’s literature in
Appendix D